Design hydraulic motor to suit my requirements. 3D Modelling, simulation and testing.

  • Durum: Closed
  • Ödül: £340
  • Alınan Girdiler: 9

Yarışma Özeti

Please bid only if you have relevant experience in hydraulics and able to show samples of previous work.

Budget for this project is £800, It is a totally new development of aluminium fishing boat. It is not a modification or adaptation.

The idea is to transfer power from the engine to the propeller by means of hydraulics as this would simplify building process and will allow to control Engine to Propeller RPM ratio during use of the boat. So when it needs to tow it can do so with more torque or if it is mowing to the fishing grounds it can go a lot faster due to the change in the rpm ratios.

We will need to make decision on how to achieve goal with minimum effort that we can get away with. In ideal world we would take existing motor that is already on the market take all internals out of it and fit them inside of our pod drive so that our pod drive become the housing for the hydraulic motor.

The pod drive or sail drive as some people call them will be made out of aluminium and will be fitted through the bottom of the boat. You will not need to develop a pod drive, you will only need to develop a motor and internal shape of it housing so that later on this motor can me incorporated into the design of a pod drive. The drive shaft of this motor will also be a propeller shaft.

Already some calculations was done and suitable manufacturers identified, so if you have experience with hydraulic motors you will only need to modify existing motor and its components to perform in different application. This will simplify our manufacturing process as we will be able to buy parts from that already available on the shelves.

Priorities for this design are:
1. Cost effectiveness
2. Efficiency
3. Easy of manufacturing and assembly
4. Minimum maintenance


Please let me know if you have any questions.

Regards Sergiy

Tavsiye Edilen Beceriler

Bu yarışmadan başlıca girdiler

Daha Fazla Katılım Görüntüle

Genel Açıklama Panosu

  • TimmyKuthiala
    TimmyKuthiala
    • 1 yıl önce

    Hi. I can give you a solution and give you the schematic and other design parameters as I am a mechanical engineer. But I am not a draftsman. You will need to get a draftsman to do the CAD work. Please do write if you want my inputs

    • 1 yıl önce
  • TimmyKuthiala
    TimmyKuthiala
    • 1 yıl önce

    Do you have the drawings and specs of the existing power train. If available, I could give you a design for hydraulic drive that could work as a replacement kit.

    • 1 yıl önce
  • totoco87
    totoco87
    • 1 yıl önce

    hello. i am mechanical engineer. i have exrerienced hydraulic, please write for me

    • 1 yıl önce

Yarışmalara nasıl başlanır

  • Projenizi ilan edin

    Yarışmanızı İlan Edin Hızlı ve kolay

  • Tonlarca girdi alın

    Tonlarca Girdi Alın Bütün dünyadan

  • En iyi girdiyi seçin

    En iyi girdiyi seçin Dosyaları indirin - Kolay!

Şimdi bir Yarışma İlan Et ya da Bugün Bize Katılın!