First, I’m a technician with no experience of programming an Arduino or whatsoever.
So I can’t help in programming and give only technical information and needs.
Measuring on a cooling unit at a sample rate of 1 measurement/minute (saving battery), 3 NTC (preferable) temperature probes and 2 reed contacts.
At a plant, there can be 20 to 30 Arduino’s fulfilling same task.
As soon as some control parameters are triggered, an alarm (contact) is generated and a led starts flashing on the housing and additional a sound alarm as well. Sound can be switched off by a push button and reactivates after a certain time if alarm still exists.
Preferable battery controlled. Arduino monitors state of the battery and alerts when battery drops below safe level.
Optionally, preferable via Zigbee (or similar but better than Bluetooth), alarm contacts are sent to a main controller, controlling all the different Arduino’s.
This main controller generates an alarm sending a general alarm to a mobile phone (Wifi) via a small app, specifying which Arduino activated.
I must be able to control the Arduino ‘decision’ software so that I can adapt easily on-site the triggering values. Temperature values needs to be compared to each other and triggered after certain elapsed safety time.
If we could follow in real-time the measured values (app on phone) while programming the Arduino, that would be great.
Specify where you think additional PCB’s needs to be added to a standard Arduino (or clone)
I need to have an idea for the small Arduino board and additional the main controller.I can see where the automated messages are cooming from
Several bidders pointed me to the fact that a ESP32 would be a better solution for this project. It's indeed a better solution=. Perhaps those not familiar with this board can retract thier bid
Bu iş için 71 freelancer ortalamada €603 teklif veriyor
Hello sir/ma, I'm interested in taking this task up for you. I am an Electrical Engineer with a masters degree and I have high proficiency knowledge in FIRMWARE: FPGA firmware in VHDL and Verilog for Altera/Actel/Xilin Daha Fazla
HI, 'I see that you need some assistant in I am expert and having 5 years of experience in simulations using MATLAB and SIMULINK in many fields including Electronics, Communication, Control System, Signal Processing an Daha Fazla