I am planning to build an automatic pet feeder for my 3 cats. I need somebody to help me with the electronics section of the project.
The below video shows the working of a single feeder. I will require the Arduino (or whatever is suggested) to run 3 different motors individually. The motors will need to rotate a specific angle in order to dispense food. I will also require ultrasonic sensors which provide feedback through a red blinking LED when food stock is low in the dispenser. At the scheduled time, a blue LED and small bell should turn on and off for 10 secs (1 sec on then 1 sec off). After this the motor should rotate the specified degrees angle.
Also, the above process should be triggered through individual push buttons for each motor.
Before starting the project, I will also require some advice on whether the above system can be set up to work through a mobile phone.
Hi there, I am a resident of Makrana, Rajasthan, and currently pursuing BTech from the ECE Department of Indian Institute of Information Technology, Bhopal. I just read your posting. It sounds like you need an expert Daha Fazla
Bu iş için 11 freelancer ortalamada ₹1109 teklif veriyor
hi..I have more than 8 years experinced in circuit design and product development..in my past I have design project for company..I can design and help you for designing feeder
hello i understand your job and i able to do it i have a more then 6 years coding MCU's and developing products please feel fre to send me massage
Hello , I am experience electronic engineer. i have 3 years arduino experience i have made many projects on arduino. this is pretty simple for me. and i also have arduino . I can do this work i hope you will give me a Daha Fazla