Develop and submit an original implementation of a 3-minute Digital Timer. The timer
must display the number of minutes in a mm:ss format using 7-segment displays
(available in the input/output pallette in CEDAR).
The timer must have the following functionality:
1. When the number of seconds reaches 0 the 10-seconds counter must be
decremented by 1 unless it equals 0, and the seconds counter reset to 9.
When the 10 seconds display reaches 0, the display must reset to 5 and the
minutes display must decrement by 1 unless it already equals 0.
2. When the number of minutes reaches 0 the minutes must reset to 9 and the 10
minutes display must decrement by 1 unless it equals 0.
3. When the timer is equal to 00:00, the counter stop running and must activate an
alarm signal (an LED).
4. A run/stop switch which toggles between the count-down function and the time set
function, and a reset switch which sets the timer to 03:00 (3 minutes) if pressed
while in stop mode.
4a. A screen-shot of your final circuit must be included in a report which you will submit
both electronically (through ESP) and on paper. Details of the report are shown below.
4 freelancer bu iş için ortalamada 175$ teklif veriyor
I am an electronic engineer with 4 years of experience. I will design the circuit, simulate it and make it practically and write a report. please contact me to discuss details
Hi I am an electronic engineer and a lecturer in a university. I think I can serve better. Please send me the report details and contact me so that we could discuss the matters in details... Thanks...