I have a rough design that needs to be converted into something an engineer or fabricator will accept as proper documentation.
The concept is for a 24 inch by 12 inch stainless steel box. The top will be slanted from a max. height of 14.5 inches to whatever the height is at the end of the box. The angle of the top will be 73 degrees.
The sides of box will have a 9.5 inch x 6.0 inch pass-thru opening, a 2-gang electrical box for a Quad electrical outlet and a 3 inch round grommet for cable management. Each of these will have approx. 2 inches of spacing between them
The top will be removable, secured by 8 screws.
The bottom will be open to allow conduits from the floor to pass cables and power up into the box.
The bottom 4 corners of the box should allow the box to be secured to the floor using .25 inch dia. bolts. (Bolts by other)
The large pass-thru side opening should have a "bridge" so that a cube shaped device can be slide into the opening and protrude about .25 inches on either side.
13 freelancers are bidding on average $112 for this job
We are using solid works 3D software and can provide you accurate drawings & models in acceptable formats. If chosen to work, we assure you our best rates, quality and turnaround time.
Dear Buyer hi, Am interested in your Job opening & am Expertise in Solidworks 2010 & Autocad 2010 pl send me message i can revert you back with Samples Kind Regards Raju.M
Hi, i am interested about this job and i can do it smoothly. Also, i can deliver this drawing in 2D or 3D. I hope you will contact me about details.