I need an enclosure designed for a Raspberry Pi 3 and a custom PCB attached to it. See the STEP file for this information.
I would like to have a custom made injection molded plastic enclosure made for it. Extra things that may not be obvious:
1) heat venting slots on the same side as the connectors on the long edge.
2) indents on bottom for rubber feet.
3) 6 holes for LED light pipes on shorter side.
4) If possible hide small USB connector and round audio connector.
I have a custom made plastic enclosure made from sheet plastic that I am using now, but it is too expensive.
STEP file showing Raspberry Pi 3 and custom board on top of it.
I will move the switch back by 2.5mm to make the enclosure easier to manufacture. Any other suggestions are welcome.
Something like this is what I am looking for:
Except, made with plastic and with the additional board, all black color, etc.
I can complete this within a few hours of the project being awarded. The bid may vary slightly according to the exact design. Relevant Skills and Experience I am a mechanical engineer with 6 years of experience of pro Daha Fazla