I need a guy who is capable of doing the following:
Configure 3 WAN links on Cisco 1911 to have failover ability i.e. to switch link for voice and data service based on priority as stated below. When primary link is down, the secondary will be up and when both primary and secondary links are down then the standby will come on. NAT is needed as well.
I have someone who has some Cisco knowledge but need someone to provide some commands that works for the above scenario that we need. Must be able to troubleshoot with our team to provide support to resolve the connectivity issues.
Link 1 (Highest priority) – VSAT
Link 2 – (Microwave)
Link 3 – (Fleet BroadBand -FBB)
18 freelancer bu iş için ortalamada 140$ teklif veriyor
Dear Sir, I'm CCIE 28528 with more than 10 years experience with Cisco products. I believe I have the skills and knowledge to satisfy your needs. Thanks,
HI I am a senior network engineer at campus network and after carefully reviewed your project needs I am sure that I can do it in just 1 working days please contact me for any further detail or question
I have configured actual production environments like this before. I have 10 years experience with CISCO and I am used to working remotely and I am able to communicate efficiently. Thank you.
Working as Network Engineer for years with wide range experience of Cisco products, including Routers / Switches (l2/l3) / Firewalls (ASA/FWSM/ZBFW) / Load-Balancer
Hi, I am working as a Solution Architect, and I have loads of experience with cisco. I would help you with this project if you would like. PM me if interested. Regards, Remarc