Help with C++ mbed project based on FDRM-KL25Z board
Bütçe $30-250 USD
A power supply system distributes electrical power to a consumer network. The amount of supplied power will be based on input sensor values that the system receives. In the system, there are three electricity generators including a primary power generator G0 and two auxiliary smaller generators G1 and G2 to provide power. Generator G0 is always ON in a normal operating condition, whereas G1 and G2 are ON only when extra powers are needed. The power supply system uses two sensors, sensor 1 (S1) and sensor 2 (S2), to detect whether extra power is needed. The sensors monitor two load points in the consumer network. A microcontroller is utilised to read and process the sensors’ values and control the generators accordingly.
Bu iş için 4 freelancer ortalamada $181 teklif veriyor
hi, i have rich experienced of C/C++ so that i can give you the perfect result. C/C++ is my top skill and i am majoring it for over 10 years. i have completed the several projects already so i have confident to comple Daha Fazla
Hi there, I'm bidding on your project "Help with C++ mbed project based on FDRM-KL25Z board" Being an expert in C, and C++ programming I can do this project for you. please leave a message on my chat so we can discuss Daha Fazla
Dear Sir! I've seriously went through your post and I have understood what you need. I am sure that I can be the best candidate who is able to perfectly complete this project Help with C++ mbed project based on FDRM-KL Daha Fazla
Have been working on firmware from last 5 years mostly on arm based controller, know about sensor interfaces and calibration. Can finish job quickly with C but if you need specifically in C++ then 25 day’s .