Design Arduino car dash
$30-250 AUD
Teslim sırasında ödenir
I am looking for a freelancer who can design an Arduino car dash. The dashboard should display the following information: Fuel, Oil pressure, Coolant temp, Trans temp, Volt, Block temp.
Using 6x SSD1306 mono displays running the U8G2 library. 6 Displays wired through a TCA9548A multiplexer.
Vehicle is a 12V system and all sensors run on resistance. These values will be supplied within a timely matter.
If additional hardware is required, please specify.
To run on a Arduino Mega.
Displays are 128x64. The display will be split in half. Bar graph 30x126pixels (centered in display). Gauge name centered under bar graph 30pixel high. This is the same for all 6 screens.
When button is pressed, screens will change from bar graph to digital (number) readouts in the centre of the top half of screen (where bar graph was), keeping name of gauge below. The number read out will have is value next to it. EG: PSI degrees, etc. Each time the button is pushed it should switch between the 2 options (bar graph and numbered read out).
Warning lights, which can work on 5V from Arduino are triggered at:
Fuel: 15L, Volt: 11v, Coolant temp: 95 degree c, Oil pressure: 5PSI, Trans temp: 110 degree c, Block temp: 95 degree c. These are separate from the screen.
Bar graph readings:
Fuel: 0-90L, Volt: 8-16V, Coolant temp: 0-150 degree c, Trans temp: 0-150 degree c, Block temp: 0-150 degree c, Oil pressure: 0-140PSI.
During start up of displays the word "TANK60" is displayed as large as possible and centered in the screen (128*64) for 3seconds on all screens.
Resistance measurements:
Fuel: 17ohm Full, 40ohm half, 120ohm empty.
Coolant temp: 226ohm @ 50degree c, 26.4ohm @ 115degree c.
Trans temp: 226ohm @ 50degree c, 26.4ohm @ 115degree c.
Block temp: TBA.
Oil pressure: 13ohm @ 0psi, 69.9ohm @ 60psi.
Proje NO: #36662304
Proje hakkında
Seçilen:
Hi I made 5 projects on these fields but the one that i developed also had more sensors because that one were for truck , ship automatic operations, tank self driving, car full control with self powering etc I can im Daha Fazla
Bu iş için 22 freelancer ortalamada $154 teklif veriyor
I understand you are looking for someone to design an Arduino car dash and I believe I am the best fit for this project. With my extensive experience in electrical engineering and electronics, along with a deep knowled Daha Fazla
I understand that you are looking for someone who can design an Arduino car dash and i believe i am the best fit for this project. I have extensive knowledge and expertise in electronics, specifically in Arduino and el Daha Fazla
Best Arduino Design Expert! ⭐ ⭐ ⭐ ⭐ ⭐ ⭐ Dear Client, With over 30 years of experience in electronics design, circuit design, and PCB design, I offer my expertise to design an Arduino car dash. The dashboard will displ Daha Fazla
I understand that you are looking for someone to design an Arduino car dash and I believe I am the perfect fit for this project. With over 8 years of experience in electronics, I am confident that I can deliver a high Daha Fazla
Hello, I am an embedded electronics engineer with prior experience working with Arduino and displays. The interesting twist in your project is that the displays need to be driven through a multiplexer, but because I p Daha Fazla
I am an Embedded Design Engineer with more than four years of experience developing Arduino and Node MCU projects. If you have an idea that you want to realize I can help you with choosing the right components, wiring Daha Fazla
Hello, my name is Adnan and I'm an experienced and results-driven professional with a strong track record of success. I'm confident that my skillset makes me the best fit for this project: I have extensive experience i Daha Fazla
Hello. ⭐ ⭐ ⭐ ⭐ ⭐ I have been working for more than 10 Year in the field of Electronic engineering (Hardware / Firmware). I have extensive experience in the areas including Circuit Design, Circuit Simulation (Analog, D Daha Fazla
Hello, my name is Anas and I am an expert electrical engineer with extensive experience in electric engineering and electronics. I noticed that you are looking for a freelancer to design an Arduino car dash and I belie Daha Fazla
Hello As a seasoned Electronics Engineer, I have profound expertise in Arduino programming and interfacing, perfectly aligning with your requirements. I can design an Arduino-based car dashboard, displaying Fuel, Oil P Daha Fazla
We have already developed a Car Dashboard(Software using Python/ nodejs ) which monitors the fuel level, Oil, Pressure, Engine Temperature, Engine RPM, Speed etc., lively from the car and monitor in the Dashboard thro Daha Fazla
As a professional electronics engineer with 4 years of experience, I have developed a strong expertise in PCB design, Arduino programming. I have successfully completed numerous projects, showcasing my ability to desi Daha Fazla
Hi there I m an Architect/Civil Engineer/BIM/CAD Expert and will offer you the Best Discount. You can pay me a reasonable price + Good Review only. I want to review your Design Arduino car dash plans/sketches,/ideas Daha Fazla
Hey, I have understood and evaluated your requirements about Electrical Engineering, Arduino, Microcontroller and Electronics. I am an Electrical Engineer with more than 5+ years of experience in Circuit designing, PCB Daha Fazla
Hello, I have read Your project description Design Arduino car dash i have done many project-related engineering, Solid work, CAD/CAM, product designing, CFD & FEA simulation, design analysis, 3D modeling, and manuf Daha Fazla
Hello. As a senior electrical & electronic engineer, I have a wealth of experiences over the last 15 years. I'm very familiar with Circuit design, PCB design and Firmware (Arduino, ES32, STM32, FPGA, PLC). So, I can de Daha Fazla
As a professional electronics engineer with 4 years of experience, I have developed a strong expertise in PCB design, Arduino programming, and ESP programming. Throughout my career, I have successfully completed numero Daha Fazla
Good morning, sir, I have seen your project, and I believe I could be a good candidate for what you are looking for. I am an electronic engineer, and my final-year project involved the development of a modular microco Daha Fazla
Hello! I read your all requirements I am Fully Expert in Microcontroller , Electrical Engineer , Electronics Arduino, circuit designing, Programming. I am well know about your project you need a arduino car dash, I U Daha Fazla
