Devam Ediyor

Analog or low frequency digital chicken coop door controller

I need a circuit and a PCB developed for the following project:

This is going to be a very simple chicken coop door controller with nothing but the essential features.

The circuit must not have anything oscillating at over 9kHz to be exempt from FCC testing requirements.

Clarification: Nothing should be working on frequencies over 9kHz in the circuit. Components that are capable to work at frequencies over 9kHz are ok.

The circuit is powered from a 12v battery or a 12v power supply. DC motor (under 1 amp) opens and closes the door, so it needs to rotate in both directions, depending on the light level.

Two limit switches to stop power to the motor when the coop door is all the way up or all the way down.

The logic is as follows:

When ambient lightning has reached a certain limit (at the time of sunrise), the motor is energized and opens the door.

At sunset, When ambient lightning again has reached a certain limit , the motor is energized in the opposite direction and closes the door.

Please include a hysteresis loop to prevent the circuit from turning the motor on and off repeatedly when the light levels are around the trigger levels

Motor should be energized for 30-90 seconds (adjustable by a pot or by replacing time delay components), after which there is no power to motor regardless of limit switches.

Temp range -25C +45C, LDR output should not deviate more than 5% within the temp range at low light (dusk/dawn).

No screen. Light level sensitivity adjustment is made by a pot.

2 buttons on board for opening and closing the door (overriding the door position until next open or close) unless this is hard to implement.

The circuit should draw <=1ma when idle.

5.5x21mm 12v jack, a small terminal block for motor. LDR mounting should have 2 options: on board and a pluggable terminal block for remote LDR installation.

Beceriler: Analog, Devre Tasarımı, Elektrik Mühendisliği, Elektronik, PCB Düzen

Daha fazlasını gör: remote control chicken coop door, building a chicken coop door, automatic chicken coop door opener motor, solar powered chicken coop door opener, car antenna chicken coop door, automatic chicken door, diy automatic chicken coop door, wireless chicken coop door, low cost pci analog digital converter, low frequency pass, mini chicken coop, chicken coop ebook, report chicken coop, short note chicken coop, report writing chicken coop, low cost digital oscilloscope, low frequency radio transmitter, chicken coop, design chicken coop, low frequency radio

İşveren Hakkında:
( 0 değerlendirme ) Nashville, United States

Proje NO: #19239856

Seçilen:

LTEDeveloper

Hello, My name is Andrei, i am a Romanian IOT Developer with a lot of experience in IOT projects and automatics . To make it analogical is nice , but the cost will be high, is more simple to make it with a MCU Daha Fazla

%selectedBids___i_period_sub_7% gün içinde 140%project_currencyDetails_sign_sub_9% %project_currencyDetails_code_sub_10%
(5 Değerlendirme)
2.7

Bu iş için 9 freelancer ortalamada $220 teklif veriyor

liveexperts123

Hi there, I have read your project description and i'm confident i can do this project for you perfectly.I still have a few questions. please leave a message on my chat so we can discuss the budget and deadline of the Daha Fazla

$555 USD in 4 gün içinde
(16 Değerlendirme)
6.0
xiaoqideng

Dear, Client. Thanks for your proposal. I did read your detail carefully. I am very interesting to your job. I am an expert and developer who have rich development experiences in many PCB design jobs. You can se Daha Fazla

$250 USD in 5 gün içinde
(35 Değerlendirme)
6.2
estebantoribio

Hi. I'm an electronic engineering student from Argentina. I've been working in freelancer.com for more than two years, and I've completed more than a dozen projects, all with good recommendations, you can check my prof Daha Fazla

$250 USD in 15 gün içinde
(11 Değerlendirme)
3.8
umg536

Hello there, This is a default bid made. we'll discuss the price later in the chat after reading your project i can do this for you perfectly.I still have a few questions. please leave a message on my chat so we can di Daha Fazla

$155 USD in 3 gün içinde
(1 Yorum)
1.8
braincenter

I DO NOT OUTSOURCE I have been a freelancer for the past 8 years, I believe that my experience and skill in this background will prove to be of great help to you. Contact me to discuss more on the details

$250 USD in 3 gün içinde
(2 Değerlendirme)
3.1
moises08021997

I'm an engineer in Instrumentation and Control. Expert in the subject and with experience. Manager of SOLUXPRO C.A I promise to be with you from the beginning until after finishing the work. Service to your needs Co Daha Fazla

$111 USD in 10 gün içinde
(0 Değerlendirme)
0.0
egazi

Hi, I am an hardware design engineer with 16 years of experience. We designed similar circuits for DC motor control. I want to work with you on this project. When we agree on the circuit, I will produce the prototype a Daha Fazla

$166 USD in 6 gün içinde
(0 Değerlendirme)
0.0
KOKTech

Hi! How are you? I am a senior PCB layout designer who has rice experience in multi layer circuit design. I am really interest in your project. I wanna work with you. Thank you.

$100 USD in 3 gün içinde
(0 Değerlendirme)
0.0