To use a proximity sensor and Arduino (or similar low cost board) to read the distance between the sensor and the flag and publish the readings expressed in mm via MQTT using WIFI connection.
2. Electrical Drawing
3. Arduino sketch - to manage reading from the sensor and publish information using MQTT
4. Calibration procedure
5. Reading range - 3 mm
6. Accuracy - 0.05 mm
7. Repeatability - 0.1 mm
8. Sensor to be oil resistant
As I'm getting a lot of question about the sensor itself. I was thinking about the Keyence EX-V or EG series (or similar sensor)
After more research Balluf Inductive distance sensors like BAW M12ME-UAC35C-S04G seams to be more suitable for the project.
Hi Would you provide the proximity sensor? I am a time served C++ programmer (20 years in industry) and have excellent previous experience in developing on both Windows and Linux as well as embedded programming on A Daha Fazla
Bu iş için 36 freelancer ortalamada £149 teklif veriyor
hello i am a computer engineer,i have masters in computer engineering,i have experience for more than 8 years in arduino and electronics i have made this project before but using ultrasonic ,so i am familiar with i Daha Fazla
Hi, How are you? I am very interest in your project. As I am a professional Expert with great experience and skills, I am sure that I can help you I'm ready to start to work on your project right now. If we clarify t Daha Fazla
Hello Sir. I have a lot of experience with these thing. I am a Mechatronics Engineer. I can do your work on time. I will be pleased to do work with you.