I need a design for an autotensioning winch.
The winch needs to be able to free wheel in anticlockwise when a device is pulling on it.
however when there is any slack in the rope, the winch needs to wind clockwise until the tension is regained. this needs to be a constant ongoing process.
The device pulling on the wire will be approximately 10kg, and the wire will go out approximately 600m.
thinking a set up including a raspberry pi with some means of tension load sensor?
7 freelancers are bidding on average $62 for this job
Professional engineer with 39 years of experience in design and development Relevant Skills and Experience I hope you need both concept and detail design
I have more than 12 years of experience in mechanical design,product design, manufacturing, Automotive engineering, AutoCAD , Autodesk Inventor, Solidworks and ANSYS
Mechanical/ Electrical designer. I am a mechanical engineer specialized with Product /industrial designing Mechanical drawing and manufacturing drawing from concept to prototype . we also do FEA and CFD analysis and Daha Fazla
Hi, Greetings....! I have experienced to design Winch start from scratch. Also have rich experience to work on PLANETARY GEARBOX, Shaft design, Bearing Selection, Break Design, Load calculation, Drum design, Daha Fazla
Autotensioning Winch Design can't be done in one day that's an open fact will definitely complete this project with in 7 days with quality work output if you knows this fact will got the project. Thank You