Design circuit

You may use Multisim

Construct a single phase, one-pulse SCR battery charger in Multisim. The same basic circuit

as in section 1 above can be used, but replace the diode with a SCR and include a 340VP : ≈

200VP (depending on your student number) step-down transformer between the ac supply

and the SCR. Implement your circuit in Multisim using ‘virtual’/ideal components. Also add

a 10-V firing/triggering pulse via a 10-Ω resistor to Gate and Cathode. You must have some

form of delay in the pulse to fire at a certain angle

Simulate typical output waveforms for the circuit (choose a firing angle α). Show voltage as

well as current – and use a current probe to send the signal to the oscilloscope. Briefly

discuss the waveforms to summarise the operation of the circuit.

• Now, from the waveforms, derive the dc equivalent voltage as a function of VM, E, and α,

where VM is the peak secondary voltage. The on-voltage across the SCR may be neglected.

• Next, derive the dc equivalent current (can’t use Ohm’s law directly, first get the voltage

across the resistor).

• For the given specs below, calculate the expected minimum and maximum firing angle, as

well as expected maximum and minimum output dc current.

The following values must be used for the analysis and iterative design of your battery charger:

• Rectified Peak Voltage: VM = 200V plus sum of last three digits of your student number.

• Battery Voltage: E = 100 V minus sum of last 2 digits of your student number (SN).

• Internal Resistance: RINT = 1 Ω plus one tenth of the last digit of your SN.

• Target Current: IDC = 2 A minus one tenth of the 2nd last digit of your SN.

Müşteri Hakkında:
( 665 değerlendirme ) Bangalore, India

Proje NO: #33742573

## Bu iş için 6 freelancer ortalamada ₹11521 teklif veriyor

(53 Değerlendirme)
7.6
Nabeelkaliyath

I'm an electrical and electronics engineer.. i have hand on experience with autocad..I'm doing work with affordable cost

₹1875 INR in 7 gün içinde
(0 Değerlendirme)
0.0
osmex917268

Hi I have more than 8 years experienced in circuit designs and development in my past I have designed lot pcb for company I can design best way without emir circuit

₹1875 INR in 7 gün içinde
(0 Değerlendirme)
0.0
ProfessorxCorp

Hi. i can deliver this project in few hours. My main motive is to provide quality content for my client. lets have quick chat for further discussion.

1 gün içinde %bids___i_sum_sub_32%%project_currencyDetails_sign_sub_33% INR
(0 Değerlendirme)
0.0
EngineerJulius29

AN ELECTRICAL, ELECTRONICS AND COMPUTING ENG Experienced in ELECTRICAL , ELECTRONICS & COMPUTER ENGINEERING With a demonstrated History of Academia in the Field of Engineering. I have research, Design and Theoretical k Daha Fazla

₹2500 INR in 2 gün içinde
(0 Değerlendirme)
0.0
eesolltd9

Hey there, I hope you are doing good. I am ELECTRICAL/ELECTRONICS ENGINEER from India with 4+ years of experience in designing PCBs. I am familiar with various CAD tools including tools preferred by Manufacturers. I a Daha Fazla

₹5000 INR in 7 gün içinde
(1 Yorum)
0.0