Devam Ediyor

Impersonating an I2C sensor via Labview

You are required to write a small Labview program to impersonate the attached SI7005 silicon labs, so we can test the main unit that acquires the signal. The signal is acquired thorugh the I2C protocol.

Basically the front panel will have two Integer inputs, temperature in °C and Relative humidity in 0-100 % scale so when labview is polled by the main unit, it should feed the user-specified values to the main unit via I2C. The communication protocol is implemented according to the datasheet by silicon labs.

We were planning to use the attached NI USB8451, but fell free to advise.

Delivery includes the Vi file and some troubleshooting assistance in case the Labview program does not work as planned.

Beceriler: Elektronik, LabVIEW

Daha fazlasını görün: i2c labview, silicon, sensor, ni, i2c, fell free, 100 i2c, write program protocol, temperature labview, humidity, humidity sensor, silicon labs, communication protocol, labview can, electronics communication, labview program, labview temperature, temperature sensor , can i2c, electronics program, troubleshooting program, i2c write, program electronics, programming labview microcontrollers, planning party project

İşveren Hakkında:
( 70 değerlendirme ) Brescia, Italy

Proje NO: #4452824

2 freelancer bu iş için ortalamada 91€ teklif veriyor

Nenad1526

I am a Certified LabView Associated Developer with a lot of experience in NI multifunction devices.

in 15 gün içinde99€ EUR
(57 Değerlendirme)
6.3
nicu66pr

I have good Labview experience and the will to complete this project.

in 5 gün içinde88€ EUR
(12 Değerlendirme)
4.6
olivioloyer

If I got it right you need a labview simulation of the T° and humidity Sensor, and the tasks are the following: -Labview program must receive a command from the main unit: => what kind of device is the main unit? => Daha fazlası

in 7 gün içinde82€ EUR
(1 Değerlendirme)
1.4