help with electronic component
$50-1000 USD
Teslim sırasında ödenir
I am looking for someone highly proficient with electronics - PCB design, MCUs, EEPROM memory chips, etc.
Looking to make some modifications to one of our company's products' boards but I don't have the proper know-how yet. So I must pick a MCU, I have an idea of what I'm looking for but need to consult with someone having more experience.
Please speak english fluently, be available over the phone and/or skype and have GREAT experience designing electronics. I don't mind paying a high rate but you must know your stuff VERY WELL.
What I am looking for in terms of a MCU:
1) EEPROM 8kb
if there are no MCUs because of this then the chip MUST BE ABLE TO WRITE TO ITS PROGRAM FLASH inside the application and NOT ONLY VIA system pin. This is a MUST!!!!! I can't stress enough how important this is, so again: chip must have read/write capability to 8kb flash/EEPROM.
Page size must be small enough not to exhaust RAM when writing to sectors/blocks which are not 100% filled.
2) RAM 8kb or more
3) Flash 24kb to 32kb
4) Clock: 1Mhz to 50Mhz
5) Power: 5V +/- 0.5% at under 150mA peak
6) 2 (two) programmable GPIO pins
7) SMALL form factor, max. 10x10 mm height x width and max 0.7 height including any leads/connectors. This is also very important.
8) in relation to 7, BGA chips are NOT preferred and QFN are preferred.
------------------------------------------------------------------------------------------------------------------------------------------------
Please submit your MCU suggestions. The bidder who submits the best match and has relevant experience working with said MCU will get a contract for PCB design, prototyping, possibly long term sourcing, and also possibly the software.
Got $$$$, do you have the skills?
Proje NO: #1611774
Proje hakkında
Bu iş için 15 freelancer ortalamada $600 teklif veriyor
Dear Project Manager, I understand that the project demands intelligent electronics design incorporated with MCU and interfacing. I am taking this an opportunity to propose my solution for the same. I have great exp Daha Fazla
Dear sir, We are capable of providing consultant service for electronics design, PCB layout and firmware development. Please visit our portfolio and see our profile. For bid details, Please check PMB. regards,
Hello 'newonsite', I am submitting my detailed bid in the PM. Kindly review the same. Thank you very much. JJdatajobs.
Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of ha Daha Fazla
Hi, I have been designing hardware and PCB layout for a long time. Additional information included.
We understand you requirement and we have experience to do this type of work. We assure you that we complete your product on time with quality. Please check your Private Message Box for more details.
I have 2 years experience on PCB design, I confident that I can do the job. I know various PCB software, just see my portfolio.
Dear Sir, I'm working in R&D with PIC MCU's and all kind of peripherals. We developed consumer product and sold above 1 Million units. Due to lack of details in your post, I'll appreciate getting expanded details Daha Fazla
I am an Senior Electronics Engineer working for a major defence contractor .I have 8 years experience in designing products (both HW&SW) for mission critical applications. Please see the PMB for the microcontroler Daha Fazla