I am looking for someone to create a pcb layout that is going to be used to read and process an analog a/c frequency output signal.
Requirements:
1. Use a Pic16F77A chip (alternate will be considered)
2. Signal range is 20 - 30 mV Use amplifier 40 - 60 db to amplify the signal
2. Sample rate to be use is 4kHZ
3. Analog Filter of 400HZ
4. Process the signals frequency and amplitude
5. Leave space in code for triggers when certain frequency and amplitude combination is hit
Hope this helps i look forward to your bids
Hi,
Our experienced team is handling the design and development of the products based on various microcontrollers 8051,PIC,ARM,PSoC families. We can provide the solution according to your requirement.
Regards,
Geo
Deliverable:
1)schematic
2)PCB Gerber files
3) code in probable use 16f676 if provider consents
cost of PCB fab+ electronic components and courier charges according to respective vendors or can be supplied by provider according to my design
adipdutt
Hi,
I have worked and designed several such projects based on PIC16F72,IC16F77,PIC18G8722,dsPIC33F3011,PIC24HJ,PIC16F877 microcontrollers. I have 19 years of design experience in Embedded systems.
Thanks,
Amit
Hello,
All your requarments are clear unless point 4. Pls. send me more details, because to process the freq. in band 2K seems to need more MIPS than PIC16F877 can deliver (5MIPS). Maybe you can send me in PMB more details.
Thanks
Miki
Sir iam an embedded engineer with 5years of experince in this field .I have lot of experience in programing PIC contollers(16f,18f,24F and ds pics).I can meet your requirements at the lowest rates and can provide you good quality of work. So if you are intrested pls PM.
thanks
Hi there. I would do your project with no problems but not the firmware. I use the best tools out there to layout your pcb out of your schematic. This is what I have done the last 8 years. Please advise. Thanks