I would like to operate 2 nema17 27:1 stepper motors. At a set time for the protocol between 15 and 40 seconds i want motor A to turn 6 rotations at speed x the 1 rotation at speed 0.5x and then a final rotation at 0.33x. All continuously and without pause. Then a 10 sec delay followed by a return to the origin by rotating 8 revolutions in the opposite direction.
I need motor B to do the same protocol in the opposite direction from motor A such that:
1st rev at speed 0.33x
2nd rev at speed 0.5x
6 rev at speed x
Then a 10sec delay followed be resetting motor B to origin via 8 rev in the opposite direction.
I would like to control this via cable connected to an android phone where i can input the time in seconds (15-40 sec) to perform the 8 initial rotations. I could use 1 or 2 arduinos but need to initiate both motor protocols simultaniously.
Bu iş için 36 freelancer ortalamada $483 teklif veriyor
Hi there I am an electrical engineers with 8+ years of experience with stepper motors. I can design this system for you with the spec provided. Let me know if you are interested.
HI I'm Arduino and electronic circuit design expert. Please check my profile for more details about previous projects Chamika Electronic Engineer
i have more than 6 years experience in embedded firmware with arduino . so i can do your job within a time limit with your satisfaction.