Rx cylindrical coil for wireless charging system
Bütçe $250-750 USD
- Freelancer
- İşler
- Elektronik
- Rx cylindrical coil for wireless charging system
I need to build cylindrical coil for RX receiver of a wireless charging system and define the TX receiver coil with main chip controller in TX and RX section.
It is not important for me the electric schematic of this project because I can made myself but I need to define commercial chip to do this application
For the TX there are not problems because I have 15x8cm of surface size.
The problem is for RX receiver because I need to use a diy cylindrical coil.
Maximum dimensions for this coil are 22mm of diameter and 45mm of lenght with 5W of power.
This coil has to be in air.
Bu iş için 7 freelancer ortalamada $450 teklif veriyor
Thanks for Freelancer which gives chance to meet you. I hope you are good. I have read your description carefully and understand everything. I’m Electronics engineer who have 25 year experience on analog design, renew Daha Fazla
Hi, I hope you are doing fine. I have PhD in mechanical engineering from Tohoku University of Japan. I have published 20 Journal papers and 16 international conference papers. I have a lot of experience in automotive, Daha Fazla
Hello, I am an electronics and telecommunication engineer and my major is wireless systems' design. I am experienced in hardware and embedded systems' design. I have designed/printed/tested many PCBs and I am quite exp Daha Fazla
Mechanical Engineer Expert Hi there, I will do this project according to your concepts and requirements. I would share previous work and samples with you. I would give high quality work and results. I’m professional m Daha Fazla