Expert for STM32 Motor Control Workbench with STEVAL-SPIN3201

$25-50 USD / hour

Kapalı

İlan edilme:

neredeyse 4 yıl önce

$25-50 USD / hour

Hello, I need a freelancer expert to handle (consult and remote assist) troubleshooting STEVAL-SPIN3201. Here is the issue description: We configured the motor according to datasheet in the STM32 Motor Control Workbench, however when starting the motor from Motor Control Workbench UI and measuring the phase with oscilloscope, we see constant PWM on all three phases regardless to the HAL sensors output. See the attached image of the scope - channels 1,2,3 are phase voltages relative to ground channel 4 is one of the HAL sensors.

Electronics

Electrical Engineering

Microcontroller

Engineering

Circuit Design

Proje No: 26583580

Proje hakkında

5 teklif

Uzaktan proje

Son aktiviteden bu yana geçen zaman 4 yıl önce

Biraz para mı kazanmak istiyorsunuz?

E-posta adresi

Freelancer'da teklif vermenin faydaları

Bütçenizi ve zaman çerçevenizi belirleyin

Çalışmanız için ödeme alın

Teklifinizin ana hatlarını belirleyin

Kaydolmak ve işlere teklif vermek ücretsizdir

5 freelancers are bidding on average $35 USD/ saat for this job

@makeideaalive

Hi! I recently have done a similar project. I worked on medical device which has a bldc motor with STSPIN32F0 as microcontroller. I was configuring motor in Motor Control Workbench. I have a lot of experience with brushless motor. I developed many algorithm for control them like trapezoidal commutation sensorless or with hall sensor, field oriented control with encoder feedback and more. Check my portfolio and message me to determine the details.

$30 USD 40 gün içinde

0,0

(0 değerlendirme)

1,9

@mustafackmk01

Hello, I master this development board and software. However, I used several boards of the ST. I can help you best.

$40 USD 40 gün içinde

0,0

(0 değerlendirme)

0,0

@ouseppachacr

I have worked in the STEVAL - SPIN3201 board and i have this board with me.I have seen the cro pwm image.i can describe more about that through private chat.

$28 USD 10 gün içinde

0,0

(0 değerlendirme)

0,0

@maheshrsharma8

I have excellent experience in motor control algorithm development on STM32 workbench .i developed the drivers for MOTOR CONTROL ac,stepper,dc,servo and all other .I developed this type HAL sensors with single and 3 phase control for motor control drives

$29 USD 40 gün içinde