Create an assembly application for the pic microcontroller to operate a digital lock on a storage
You should design your application using an appropriate method (flowchart/pseudo code) and then implement this on PICSIM board 1. The specification of what is required is as follows:
You will use two buttons (RA1 and RA2) to cycle up and down the 16 codes available, and use a third button (RA3) to select that code. You will display the code as an LED bit pattern on portB (bits 0:3).
If the code is the same with a predefined password when selected you will open the lock (shown by turning on the RA0 LED).
To close the lock, you will need to set the correct code then press the OK button (RA3) again,
also turning off RA0.
If the lock is open, you can change the password by selecting a new code using the up and down buttons then pressing RA4.
Hello, I usually work programming PIC microcontrollers, both in Assembler and C I have read your project's specification and I find it simple to be fastly implemented. I can implement this project as soon as you Daha Fazla
Bu iş için 4 freelancer ortalamada $26 teklif veriyor
Dear Sir. How do you do? I have seen your description very carefully and posting to you my idea. If you give me a chance to interview, I'll explain in more detail and I'll do my best for you. I will work hard and ha Daha Fazla
Hello. I have good experience in PIC micro-controllers . I have done many projects related to PIC 12F, 16F series. Kindly contact me. Regards Faizan