I need a PCB which is 1cm x 7cm and thickness doesn't matter too much as long as its as thin as possible.
I want to be able to click a button 10 times to call a person and then be able to use a bone conduction speaker to listen to what the person is saying and reply using a microphone. Please make it as small as possible and have a decent amount of battery.
Bu iş için 4 freelancer ortalamada £31 teklif veriyor
I can help you in this project. But i have some qustions about this task. I have more than 15 years experiance in design electronics and developing firmware. Best regards, Victor.
Hello, I am a senior device developer. I have plenty of experience in firmware development and micro-controller developments. I can write the firmware based on Arduino, Raspberry Pi, Pic, Atmega, FPGA, ARM, DSP and so Daha Fazla