Develop Service and Repair manual for existing electronic products - repost

I am an independent business which has performed service and repair on NuTone brand electronic Intercom Systems for the past 30 years. There are two models made between 1994 and 2006 which NuTone never produced or published any Service Manuals for. These two models share an underlying design.

The only technical information that is available for these models are some basic schematic drawings. The original engineer who designed these models no longer works for NuTone and is not interested in developing any service related information about these designs.

I am looking for an independent electrical engineer to aid my company with the following tasks:

1. Provide a basic description of how these models are designed and operate, based on the limited technical information available. The description needs to be written in language that can be understood by someone with electronics experience but is not an engineer.

2. Provide a troubleshooting guide for common problems that occur with each model. This does not need to be a step-by-step guide, it does need to point to the likely cause for the failure that has occurred.

Finally, the person who has performed the tasks listed above will need to be available by phone and email to discuss and answer specific questions about these two models. This support will need to be on an as needed basis while I develop the repair procedures for these models. The frequency of these support requests will likely diminish as I become proficient at repairing these models.

If you are interested in this type of project, please contact me.

Thank You

Chris Peters

Beceriler: Elektrik Mühendisliği, Mühendislik, Mikrodenetleyici, Teknik Yazı

Daha fazlasını gör: writing procedures, writing a thank you email, who need an engineer, which company need a engineer, technical writing service, technical writing manuals, products designed, phone support service, need electronic engineer, need electrical engineer for electrical company, needed electrical engineer, need a engineer for my company, need a electronic engineer, looking for electronics engineer and design, looking for electronic engineer, looking for electrical engineering, looking for a electronic design engineer, i need an electronic project designed, independent engineer, how to be a engineer, failure by design, engineer of electronics, engineer no experience needed, electronic systems engineering, electronics engineering company

İşveren Hakkında:
( 0 değerlendirme ) Danville, United States

Proje NO: #4443663

Bu iş için 6 freelancer ortalamada $43/saat teklif veriyor


Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of ha Daha Fazla

$47 USD / saat
(16 Değerlendirme)

Hi Chris, I am an experienced electronics engineer with previous industry experience in embedded systems and analog/digital electronics. I have also experience in preparing documentation and process instruction mate Daha Fazla

$33 USD / saat
(1 Yorum)

Hi, Ready to write technical doc for you

$27 USD / saat
(3 Değerlendirme)

I have experience in developing operating manuals

$55 USD / saat
(1 Yorum)

Iam an electronic and communication engineer. And forsure i will help you in this Plz check pm

$44 USD / saat
(0 Değerlendirme)

Sounds like a great project. I am an Electrical Engineer and would be happy to help Darryl

$49 USD / saat
(0 Değerlendirme)

Hello- I just recently created an account on freelancer.com and a handful of other freelance websites to start pulling in additional work and projects for my internet marketing services company. I have been personally Daha Fazla

$55 USD / saat
(0 Değerlendirme)

My name is Faraz Ahmad (Electrical Engineer) from Pakistan. My expertize are 1. Article/ Report writing 2. Renewable Energy ( Solar Panels and Wind Farms) 3. Control Systems (Continuous and Dicrete) 4. Power Syste Daha Fazla

$27 USD / saat
(0 Değerlendirme)