The objective of this project is to modify existing firmware to interface sht30 sensor with PIC microcontroller.
The existing firmware was written for HDC1080 Humidity sensor and works fine. However HDC1080 sensor was replaced with sht30 and now a firmware update is required to get values from sht30.
Code is written in MPLAB and is fairly documented. The major portion of the code deals with menus on LCD, which works fine so only changes will be required are "to read humidity values from sht30".
Ideal candidate will have prior experience with sht30 sensors and PIC microcontroller programming using MPLAB.
Please start your response with the default I2C address of sht30 and we will know you are interested.
0x44 Hi, I've good experience with microchip PIC microcontrollers and MPLABX, your project looks straightforward, I'm available to start right away. Do you have the hardware ready to test it? Let me know if you hav Daha Fazla
0x44 is the default I2C address of sht30 (with ADDR pin low); alternatively 0x45 with ADDR pin high. I have experience with PIC MCU and MPLAB and even if I have not been working with the sht30, but I have lots of expe Daha Fazla
Bu iş için 19 freelancer ortalamada $137 teklif veriyor
Default i2c address is 0x44. I have 10 years experience in programming PIC micro controllers. Please share existing firmware and pin diagram of the PIC interfaces. We can discuss Regards Senthil