We have written a program to control a rotator arm, as well as communicate with an HP network analyzer using a GPIB connector. Everything concerning the rotator arm works fine, however we are unable to communicate with the network analyzer. When we try to do anything with the network analyzer, it gives us an error. A screenshot of the error is attached. We're pretty sure the issue is that the drivers we have for NI488.2 and NI common are the wrong versions, but we can't figure out which drivers to use. This shouldn't be a difficult issue to resolve for those experienced programmers out there.
We will be able to provide the code to you.
Bu iş için 12 freelancer ortalamada $144 teklif veriyor
Hi, I'd like to help you on this. The screenshot suggests that the assembly can not be loaded so I believe your initial assessment is correct. My bid covers the time I expect it will take to resolve the issue. We will Daha Fazla
Hello Mate, We have 6 years of experience of core development and we have Experienced team
Confident to fix the same, but cannot assure the schedule until see all the codes. If you're interested with my profile, let's proceed. 25% deposited need, when confirm balance 75% deposit need instantly. thanks
Hi, I am an experienced programmer and familiar with external libraries. I think the program should be recompiled using your existed libraries and some minor change should be made. The task doesn't take so much work, j Daha Fazla
Had the same problem... Should be easy to solve, with appropriate insight in your code and project configuration.
Hi...I am interested in working on the same, please provide additional information regarding the issue.
Hi I am ready to start with the task. your though is correct enough to resolve the problem. Please check the PMB for more detail.