I am an individual hobbyist.
I would like to have a Standalone Arduino Uno PCB with all materials in a BOM so as to make an order
from EasyEDA website (not necessary this website, I just mention to this one because I watched some youtube videos and learned a few things)
This standalone circuit it will be a classic Uno standalone with extra some pin headers so as to be ready for programming with either an FTDI adapter either (100 nF included, RTS, Rx,, Tx pins, supply) or with a classic Arduino Uno board (without its ATMega328 on it), so the PCB should have some headers stand by for Uno board's RESET,Rx,Tx and supply pins.
The difficulty that I face is not in the schematic in easyEDA but in the order of the materials.
For an example, it is convenient to me either the PCB to have thru hole so I myself install the DIP resistors, chip, etc or to make an SMT order so as the board to come ready to me.
In any case I want the ATmega328P chip to be in DIP package so as to remove it if I want.
I know that for someone they know, it is not a big or difficult problem, it's a matter of 30 minutes at most.
I never order a PCB so I don't want to take the risk.
Hello! I will make standalone PCB for you. I will make DIP based design so that you will be able to mamage the components as you need. Kindly come over chat and plan the project.
Bu iş için 10 freelancer ortalamada €103 teklif veriyor
Hello Sir, This is Sakib. I am professional Embedded System Engineer and PCB designer. Having experience on this platform 3+ years. I am quite familiar your problem that your talking about.I can give solution with perf Daha Fazla
✋ Hi! I can complete your project with perfection & I am experienced to your project. Kindly come to chat and let me show you my presentation of project. I had done similar microcontroller based development board befor Daha Fazla
Dear employer, I hope you are doing good. I am ELECTRICAL/ELECTRONICS ENGINEER from India with 4+ years of experience in designing PCBs. Familiar with various CAD tools including Easy EDA. I am interested in doing this Daha Fazla
Hi, I am an Electrical, Electronics and Embedded Engineer. A PCB Designer, Arduino/Raspberry Pi, ESP32, ESP8266 and internet of things expert. I read through the job description very carefully and I am absolutely sure Daha Fazla