Devam Ediyor

Slide & Buttons - Repost

Hello, I am attaching a file of a project that someone else started. However, it is only about 80% complete. The project consists of a "SLIDE" and 2 "BUTTONS". The buttons are exact in every way, except height. One will be 7.5 mm and the other will be 1 cm. These buttons need a way to sit flush on the slide and snap on. In addition, the slide needs a sexier shape. The function and the dimensions are fine, but it needs to have a slight "S" shape to make it look more fun and playful.

Also note that the SLIDE and BUTTONS will be injection molded, but in different plastics. The slide will be in polypropylene and the buttons in a synthetic rubber so this needs to be taken into consideration for design.

I would like the buttons to maintain at least a 3mm thickness.

You may notice that the slide curves up slightly. That is necessary, but the buttons also need to follow this contour. You will also notice that the buttons are placed off-center. That too is necessary. Please advise. Thank you. Denise

Beceriler: CAD/CAM, Mühendislik

Daha fazlasını görün: snap on, fun function, design molded plastics, contour design, rubber, plastics, fun center, denise, file injection, curves project, polypropylene, slide look, design slide project, rubber design, slide project

İşveren Hakkında:
( 0 değerlendirme ) Rajahmundry, India

Proje NO: #4387677

Seçilen:

caddesignguru

Hired by the Employer

8$ USD / saat
(3 Değerlendirme)
4.6