I need two telecommunication projects. Details are provided:
Discovery and Verification of Neighbor Positions in Mobile Ad Hoc Networks
MOBILE COMPUTING, FEBRUARY 2013
Technology Implementation: JAVA
A growing number of ad hoc networking protocols and location-aware services require that mobile nodes learn the position of their neighbors. However, such a process can be easily abused or disrupted by adversarial nodes. In absence of a priori trusted nodes, the discovery and verification of neighbor positions presents challenges that have been scarcely investigated in the literature. In this paper, we address this open issue by proposing a fully distributed cooperative solution that is robust against independent and colluding adversaries, and can be impaired only by an overwhelming presence of adversaries. Results show that our protocol can thwart more than 99 percent of the attacks under the best possible conditions for the adversaries, with minimal false positive rates.
2. Project 2 :
Automatic Street Lamp
SIMILAR TO THIS
First, let us understand why to use Automatic room Lamp? Now-a-days we are going through lots of advertisements of saving electric energy. With the help of Automatic room Lamp we can save and reuse energy. Find the simple block diagram of Automatic room Lamp.
BLOCK DIAGRAM of Lamp
The above block diagram of Automatic room Lamp used to disables the room lamp at day time and enables at night time. Light Dependant resister(LDR) is the key element of Automatic room Lamp.
We need to fix LDR Circuit near to the window/door of home where it can receive maximum sunlight. At day time if we open the door, the resistance of LDR Circuit reduces and leads the transistor to remain in cut-off state. So the relay doesn't energize enough, and lamp remains off.
At night time, the resistance of LDR Circuit becomes high and its makes the transistor from cut off state to conducting state. The relay becomes energize and makes lamp to switch on.
We need power supply too operate the following operation.
BLOCK DIAGRAM OF Power Supply
This is block diagram of basic power supply circuit. Transformer is used to step up or step down the input voltage. The bridge circuit is used to convert the alternating current to a pulsating direct current. Since pulsating dc is not desirable, we used filter to convert it to more desirable dc. Regulator is used to maintain the output of the power supply at a constant level.
Operated only at +5V(d.c)
No use of man power
3. Hospital Management System Using Smart Card is like minicomputer process to run with programming. Smart card system is very secured process to start and access the data in the chip and works as secure data exchange. This smart card data technology is a privacy protection mechanism in handling the personal health information and sensitive information of patients.
Hospital Management System Using Smart Card Project Abstract
It is not an interface to provide display, so smart card readers are used to read the data from smart card only. The operating system of smart card is having two sections.
First card is based on disk-drive and second card is operating system. Smart card has 1k of memory space to maintain the database for patient name, photograph, medical records, and recent treatment and for test reports etc., to help this system patients get their treatment quickly by their doctors.
Bu iş için 9 freelancer ortalamada $139 teklif veriyor
Sir I'm engineer and I'll provide you 0% plagariasm. I have done a lot of reports like this.I used Harverd method for references. For more details contact me. i will show yo some samples.
I'll be able to assist with the reports here though to make sure that we're on the same page, this needs a bit of discussion. So I'm looking forward to your response now.