I need a solution for the following issue:
I run latest version of Flussonic 20.10 with 1080Ti GPU, Installed and configured as per Instruction on Flussonic website (nvidia driver 460) enabled GPU statistic and added streams. I transtode 1080 to 720p which in current setup should easily handle 30/streams. The GPU transcoding works fine on 3 streams if I add 4th or more streams to be transcoded with GPU it will not input the stream (delay and fail) causing Error. Stream will go offline. It will not effect other streams but any stream above 3rd GPU transcoded. If I disable transcode it will process the stream. Also if I switch GPU to CPU transcode it will transcode 1080 to 720 even if its 4th, 5th or 6th stream until I reach 100% CPU usage. When I use 3 streams on GPU the load on GPU is not even 5% so it's not overloading. Looks like GPU can only handle 3 transcoding streams but its not overloading GPU is just rejecting where much less powerfull CPU have no limit as much as it can handle. Not sure if any additional config is required but I followed instruction and used flussonic for transcoding 2 years ago in past on older version and didn't have this issue it was great so I find it strange not to work as expected.
I will pay you for helping me with this!
Bu iş için 2 freelancer ortalamada $23 teklif veriyor
Hi there, I'm a video streaming expert and a software developer with more than 20 years of professional experience. I made transcoding software + DVB capture called SkyCaster. I had similar problem but i managed to f Daha Fazla
Just a note to GPU encoding (not specific to Flussonic 20.10). These NVidia cards have 1 or 2 transcoding chips (so called NVEnc chips to perform the video encoding by HW), which are unrelated to the CUDA cores. So yo Daha Fazla