...(Multi-Drop Bus) – protocol, that is used to connect the separate modules of the trading automate to a general splint, which supports the logic and the way they work. The main microcontroller of the device is the one that controls everything and sends commands to other devices (coin collector, banknote collector and card reader). The controller needs to
IFGtech is a subsidiary of IFGworld (IFGwor...We are searching for an electrical engineer that has experience in: -Design of PCB boards -Printing of PCB boards and soldering of individual components -Design new EMG microcontroller in tandem with biomedical engineers. While hours will be flexible, the goal is to produce prototypes as fast as possible.
...relatively easy to configure) to accommodate the required functionality. 2. Develop the CPLD/FPGA code. The device needs to take as inputs a set of states (from a microcontroller so either as an I2C command or as a 3 digital input code, along with 3 digital inputs - alarms). The device then needs to set 11 outputs based on a 4 input truth table
I have a simple device that I will need to control and monitor from from a PC via its USB port. This device will have an I/O port (one for for 8-bit input and one for 8-bit output ). Also, apart from the I/O, I will need a few additional lines to work as CONTROL lines. The interface circuitry could be built using an ARM Cortex micro-controller, or use an available standard USB interface chips. In...
I need to make the piezo counter display, 2 seven segments 1.8 in. t...seven segments 1.8 in. the piezo will send low voltage (1 to 5 Volt) to the microcontroller, according to of each puls the microcontroller is going to counting and display it, one reset button to reset the micro controller, I need use Arduino to program the microcontroller (Atmel).