PCB design for rechargeable flashlight
$10-30 USD
Teslim sırasında ödenir
I need to create a rechargeable flashlight with SMD components, which allows to charge the battery of 3.7 v and 190 mAh, also when the device is turned off if it is connected for its charge it has to show the level of charge in which it is, and when it is it is turned on you have to turn on the led lights and also be showing the level of charge.
the pcb has to be as small as possible
Proje NO: #16543772
Proje hakkında
Bu iş için 19 freelancer ortalamada $61 teklif veriyor
Hello there! Hope you doing good! If you still need this to be done, be sure to contact me. Lets make something awesome! Greetings!
Hello, I can design a schematic and make PCB layout for your device with single cell 3.7V Li Ion battery charger. It will have three SMD ICs, some resistors and connectors as needed. We should decide on battery size an Daha Fazla
Hello sir I hope to be a good fit for you Embedded system engineer with three years experience in electronics and electrical circuit design. I have proficiency in following software tools: Electrical circu Daha Fazla
Hello In addition to the schematic , Layout and Gerber file will assist you and guide you if you would like to produce it on larger scale , it is not just about design it could work but too expensive to Manufacture Daha Fazla
Hello, We do have work on the PCB design for a flashlight. We have gone through your project description and would like to discuss a few points. Here is our core competency in PCB and Embedded system. Softwa Daha Fazla
I can do the layout design task in Eagle or Zuken with no issue. I can convert schematic files fron other CAD tool by myself.
I have done projects similar to this, and have dealt with high complex and high density boards, hoping for a positive response
Small SOT23-5 battery charger up to 0.5A, cmos operation amp to detect battery voltage and show on low current led. You like diff led color or not? which led you plane to use? battery and switch case? Novica
