Simple Android Project switch and buzzer must be completed and submitted in tinkercad.com

$10-30 USD

Tamamlandı

İlan edilme:

neredeyse 3 yıl önce

$10-30 USD

Teslimde ödenir

Build it in [login to view URL] to test and submit. See attached document with nice table showing all conditions. But I will try to write it out for you here: - 12 volt power supply must be used to power Arduino. (Make it simple and efficient for power) - There is momentary switch (normally open), On/Off switch, Buzzer and 2 LEDs. - Depending on the condition of the switches the buzzer and LED will sound and flash. For details about the timing and conditions see the attached document. I will email you a shared link where you can build it and test in my tinkercad. Check out [login to view URL] and setup you own account so I can share a link if this project is awarded to you. Thank You! Jim

Proje No: 30568878

Proje hakkında

4 teklif

Uzaktan proje

Son aktiviteden bu yana geçen zaman 3 yıl önce

Biraz para mı kazanmak istiyorsunuz?

E-posta adresi

Freelancer'da teklif vermenin faydaları

Bütçenizi ve zaman çerçevenizi belirleyin

Çalışmanız için ödeme alın

Teklifinizin ana hatlarını belirleyin

Kaydolmak ve işlere teklif vermek ücretsizdir

Seçilen:

@soltracker

Its me Imad, The number of simulations done myself in tinkercad and proteus are around 500. Thanx for posting the job.......................

$30 USD 2 gün içinde

4,8

(59 değerlendirme)

4,7

4 freelancer bu proje için ortalama $34 USD teklif veriyor

@Gerrard97

Hello, thank you for your job posting. I read your description about your project I am a senior electrical engineer. I have plenty of experience in firmware development and micro-controller developments. I can write the firmware based on Arduino, Raspberry Pi, Pic, Atmega, FPGA, ARM, DSP, PLC and so on. And I can design the circuit by the Altium, Eagle, KiCAD, Allegro & OrCAD, PADs. I provide the services - Gerber files, Netlist generation, BOM generation and 3D Models of PCAD and ECAD. I am also good at AutoCAD, Solidworks. And I can simulate all circuits with Proteus, LT-spice, Matlab, Simulink, Multisim, and Labview as well. Due to my experience in firmware development, I will bring you the perfect result in time with high quality. I will also give you a detailed explanation of the process. Looking forward to hearing from you soon Thanks

$20 USD 7 gün içinde