Deploy custom RISC-V core on FPGA and run C codes

£20-250 GBP

Kapalı

İlan edilme:

yaklaşık 3 yıl önce

£20-250 GBP

Teslimde ödenir

Hi! I want to deploy a custom RISC-V processor on FPGA. There are two tasks: 1. Deploy the core to run C codes on it and blink an LED (the core is implemented in Verilog and synthesizable). 2. Boot Linux Kernel (files are ready). I want to deploy the processors on the ZCU102 Zynq MPSoC Board (Zynq UltraScale) FPGA.

Proje No: 30110477

Proje hakkında

4 teklif

Uzaktan proje

Son aktiviteden bu yana geçen zaman 3 yıl önce

Biraz para mı kazanmak istiyorsunuz?

E-posta adresi

Freelancer'da teklif vermenin faydaları

Bütçenizi ve zaman çerçevenizi belirleyin

Çalışmanız için ödeme alın

Teklifinizin ana hatlarını belirleyin

Kaydolmak ve işlere teklif vermek ücretsizdir

4 freelancer bu proje için ortalama £409 GBP teklif veriyor

@IslamAdam998

Dear sir, I am a digital design engineer expert in FPGA and ASIC design flows using Verilog and VHDL programming. Also, I am experienced with Vivado, ISE, Vivado IPs, SDK, Quartus, Design Compiler, IC Compiler and others. I have done master project on RISC-V. We run many algorithms on it and report the power on vivado. I can do your project, it is kind of similar. Please contact me to discuss more about this project. Kindest regards.

£250 GBP 10 gün içinde

5,0

(43 değerlendirme)

6,1

@Code4DataScience

Hi, I have extensive experience with C and some experience with FPGA. Are you available to discuss this? I will shortly be starting a perminant position doing FPGA development full time. Until then I have a few weeks left of freelancing. If this is a project which will take longer than 2-3 weeks then I can potentially continue working part time. Please send me a message and we can perhaps arrange a Skype call. Thanks

£135 GBP 7 gün içinde